Liyang Kangdawei Industrial Co., Ltd.
Liyang Kangdawei Industrial Co., Ltd.
Add to Cart
Easy To Spray RTV Silicone Sealant Chimney Anti - Corrosion Interface Rubber Super Acid Resistance
With good thixotropy, easy to operate, the rubber would not flow when operated on the facade. Whether component A and B mixed evenly could be confirmed by the change in color, it is easy to control during the construction. It is convenient to add component B, the on-site operation is simple, according to the different season and construction site condition, it is convenient to change the ratio of component A and B and control the operation time after mixing, which meet the requirements of construction and curing time.
3. KDW-987 (Chimney anti-corrosion interface rubber):
With modest viscosity, not easy to flow, easy to smear and use. The product will cure at room temperature, no strings attached, cured into elastomer by absorbing moisture in the air.
1. KDW-116 (Prime coating):
1) Clean the surface:
Clean the surface of chimney inner wall as general surface, remove dust and greasy dirt.
2) Sizing:
Take the prime coating out of the package, spray it on the surface of chimney inner wall with professional spraying tools, and just dried at room temperature.
2. KDW-982 (Chimney anti-corrosion masonry rubber):
1) Mix rubber:
The recommended ratio is 10:1(component A: component B), and the operation time would be 1 hour when the operation temperature is 25℃. Increasing or decreasing the amount of component B within ±15% to speed up or slow down the curing speed.
2) Stir:
Completely stir the rubber with electric tool or other stirrer, the mixed rubber should be black, if it is white or too shallow, or local color is too deep, it is needed to stir until evenly colored.
3) Paste:
Evenly smear the mixed chimney anti-corrosion rubber on foam glass bricks or light vitreous tiles, ensure that the thickness of rubber between bricks and chimney inner wall is not less than 3mm and the thickness between bricks is not less than 1mm.